# Problem after firmware update

**URL:** <https://forum.reekon.tools/t/problem-after-firmware-update/1569>\
**Category:** T1 Tomahawk\
**Created:** [November 18, 2023, 8:25pm UTC](https://forum.reekon.tools/t/problem-after-firmware-update/1569 "2023-11-18T20:25:19Z")\
**Posts on this page:** 3\
**Page:** 2

<div class="post-metadata">

**Author:** ![doug.gaff](https://yyz1.discourse-cdn.com/flex029/user_avatar/forum.reekon.tools/doug.gaff/32/86_2.png) [@doug.gaff](https://forum.reekon.tools/u/doug.gaff)\
**Post date:** [December 23, 2023, 3:29pm UTC](https://forum.reekon.tools/t/problem-after-firmware-update/1569/22 "2023-12-23T15:29:28Z")

</div>

Thanks. I’m not sure what sequence made it finally work and go into calibration mode but I finally got it to update after 5 or 6 tries. I pulled the battery more than once during my tries.

---

<div class="post-metadata">

**Author:** ![busbys](https://avatars.discourse-cdn.com/v4/letter/b/b19c9b/32.png) [@busbys](https://forum.reekon.tools/u/busbys)\
**Post date:** [December 29, 2023, 9:37pm UTC](https://forum.reekon.tools/t/problem-after-firmware-update/1569/23 "2023-12-29T21:37:07Z")

</div>

I received my T1 the other day and the firmware upgrade worked without issue, but the setup process will error every time. I go through the blade selection (I have B - as it says on the tape) and follow the instructions, but after the 276" length, it errors out every time. I have tried variations (selection of blade A, etc.), however, nothing seems to work. Any suggestions would be helpful. Thank you!

---

<div class="post-metadata">

**Author:** ![therock](https://yyz1.discourse-cdn.com/flex029/user_avatar/forum.reekon.tools/therock/32/9_2.png) [@therock](https://forum.reekon.tools/u/therock)\
**Post date:** [December 30, 2023, 5:29pm UTC](https://forum.reekon.tools/t/problem-after-firmware-update/1569/24 "2023-12-30T17:29:41Z")

</div>

Hello! Please see support articles below:

> **[Blade Setup Troubleshooting](https://support.reekon.tools/hc/en-us/articles/21374371605524-Blade-Setup-Troubleshooting)**
>
> Values Too Far Out of Range
> If you see the below message, it means that the alignment of each step was not completed correctly.\\
> 
>  Please repeat the processing ensure the following:
> 
> Move slowly fr...

> **[Blade Setup (Calibration) T1 Tomahawk](https://support.reekon.tools/hc/en-us/articles/18037612181780-Blade-Setup-Calibration-T1-Tomahawk)**
>
> The Blade Setup process is a procedure designed to ensure the markings on the tape measure blade perfectly match the digital screen display.  The process is very simple and is performed at the fact...

If those dont help, email us a video of you doing the process and our team can take a look! - contact@reekon.tools

[Previous page](https://forum.reekon.tools/t/problem-after-firmware-update/1569.md?page=1)