I was using The T1 yesterday for the first time for actual application. I took for measurements then clipped the T1 on my pants picket and walked outside to make cuts. When pulling the T1 out, I noticed that I not only had my 4 measurements I needed, but and additional 12 random measurements listed on my e-paper… seams like the unit was adding number while I walked… these number were much higher than I had even pulled the tape measure out… I only had taken 4 measurementsand around 34 inches, but the numbers displayed on the e-paper after the 4 original measurements were up around 125-215 inches.
Hey Duff, that seems weird. Can you see if that behavior is repeatable and, if so, send a picture of what is being displayed?