Having trouble calibrating the measurement blade on the T1M

Hardware Support & Troubleshooting T1M Utility
1

The T1M first had problems asking me to go from 10 inches to 0 inches over and over again.

I did a firmware update, but had the same problems.

I turned the unit off and tried again with the same problems.

I turned the unit off again and pulled the blade in and out several times until it gave me a random number measurement. This time it allowed me to go through the calibration setup, but when I got to the end it told me I had to try again.

Repeated attempts have all failed.

I have read about similar problems on the T1, but I don’t think the battery is removable on the T1M.

What else can I try?

2

Hello, do you mind taking a video of what you are doing so we can see if there are any obvious issues?

You can also find the full support article here as well - https://support.reekon.tools/hc/en-us/articles/37495159409812--T1M-Blade-Setup-Calibration